Node Connections for a Subnet
With your motors and sensor connected to your individual ConveyLinx-Ai Family Module, you will need to connect the Ethernet network cabling from module to module in a daisy chain fashion. The most upstream module in the direction of flow is node 1.
*Please note that the Flow is based upon the Ethernet cable routing during the Auto-Configure Procedure. The Flow direction cannot be changed or over-ridden. The only way to change the Flow direction is to perform another Auto-Configuration Procedure
!Conveylinx-Ai family can only support Ring topology with Siemens and ProfiNet switches
Subnet with Left to Right Flow
Subnet with Right to Left Flow
Subnet showing one module on the opposite side of conveyor
