3.2.4. Lift stop/s configuration (BVA 2 relays)

1. Click on the lift stop to configure and choose the kind of button of the lift stop. There are three possible choices:
   • Double: For buttons with up and down touch
   • Simple: A single button for both purposes
   • Without device: For installations where it is not desired to install a BVA device
     
     
     Configure the relays as they are going to be connected later at the installation.
     
     
     Pressing on Check the connections, it is possible to observe an example of the connection of the buttons and relays.
     
2. From this step, it is compulsory to use the Nayar Systems App. Press the LINK button. The device that is desired to link must be located near the Smartphone used for configuration.
   
   
   There are two ways of linking the device:
   • Click on the ID of the device (see previous image) which corresponds to the device to configure.
   • Click on the Discover button of the device to link.
     If the device has not been configured before, it would be necessary to wait for 10 seconds until it is configured, otherwise an alert message will be shown: “The lift stop’s device is configured”.
3. Repeat the process on every lift stop’s device remaining.

When configuration is finished it is necessary to wait at the facility screen until devices are updated. If BVAs are not in a near range, the installer must approach the devices to update them.