PWA Setup and Installation – on Brain

Overview

In order to use a PWA with Kramer Control you will need to enable SSL connections to the SL hardware. In order to enable SSL on the SL hardware you will need the following .pem files:

• Server certificate.pem file
• An unencrypted serverkey.pem file
  • Currently, we only support unencrypted server keys and we look to add this function in later releases
• A root ca certificate
  • The root ca certificate will be used on the client device used for the Kramer Control application

!The creation and management of these certificates is outside the scope of Kramer. We recommend speaking with the IT administrator of the installation site to provide the above information.

*The only supported file type for the Server certificate and Server key files is .pem

Installing the Certificate Files

1. Launch the Brain UI webpage
2. Scroll to bottom where new option appears for SSL
3. Expand this selection

Choose the Certificate option

• Here you can drag and drop the file from your machine to load the certificate or you can click on the lick grey box to open the file explorer of your machine
  

Next choose the Key option

• Here you can drag and drop the file from your machine to load the certificate or you can click on the lick grey box to open the file explorer of your machine
  

Once you have uploaded both the certificate and the key, select the On/Off option – then On to enable SSL

Confirmation

If you followed the steps correctly in the last section you should see a new SSL status in the Brain info of this same webpage

You can also confirm this by opening a new browser tab and going to “https://:8443” and you should see the below webpage

Troubleshooting

If the above webpage does not load take a look at the next article for ideas on what the issue could be

Copyright © 2023 Kramer — Powered by