This section outlines how to successfully perform a scan using the neuroTHERMAL (Thermography).
*There are two versions of the wireless neuroTHERMAL: with and without an onboard screen. If you are using an INSiGHT Bridge, you must ensure that the onboard screen version has been set to the BTC mode. This can be verified by plugging in the charging cord while connected to a PC, INSiGHT Bridge or approved USB charging device and seeing BTC in the upper right corner of the screen. If BLE mode is installed, you are advised to contact Technical Support to change this setting. If you attempt to connect with the device in the wrong mode, connection will fail.