With a paired neuroCORE, you can switch from Standard to Enhance Mode and edit your frequency settings.
To toggle between Standard to Enhanced Mode, follow the below steps:
Step 1: Go to Settings (Fig. 1).
Step 2: Go to Manage INSiGHT Bridge (Fig. 2).
Step 3: Select “Manage” (Fig. 3).
Step 4: Select the “Mode” (Fig. 4).
Step 5: Select “Yes” to toggle (Change) from the Mode you are currently using (Fig. 5).
For more on enhanced mode, click here.
 Fig. 1 |
 Fig. 2 |
 Fig. 3 |
 Fig. 4 |
 Fig. 5 |
*To toggle neuroCORE Frequency between 60Hz or 50Hz, follow the below steps (After following Steps 1-3 from above):
Step 1: Select “Frequency” (Fig. 1).
Step 2: Select “Yes” to toggle (Change) from the Mode you are currently using (Fig. 2).
 Fig. 1 |
 Fig. 2 |
These filter values are to be set as follows: 60hz if for North America, 50hz is for most other countries. This allows Synapse to filter out “noise” generated by electrical devices.
