NOTE: If you have previously paired your INSiGHT Scanning technologies to Synapse or to a previous INSiGHT software, you may be taken through the manual pairing process. This happens when your instrument is not automatically detected due to a previously established bluetooth connection within the device.
For first time set-up:
Step 1: After onboarding your INSiGHT Bridge, you will be taken to a screen to set-up your technology.
Step 2: Choose your instrument (Fig. 1).
Step 3: Be sure your instrument is powered on (Fig. 2).
Step 4: Synapse will not detect your instrument and will be given a choice to choose to pair your instrument manually (Fig. 3).
Step 5: Enter the MAC Address located on the back of your instrument and choose “Enter Manually” (Fig. 4).
Step 6: Your instrument will successfully connect (Fig. 5).
Step 7: If you have additional instruments to pair, choose “Add more instruments” from the screen seen on Fig. 5.
If you exit this screen or would like to resume pairing later, you can add instruments at a later time by doing the following:
Step 1: Choose Settings from the home screen (Fig. 5).
Step 2: Choose Manage INSiGHT Bridge (Fig. 6).
Step 3: Choose Manage (Fig. 7).
Step 4: Choose Add Instruments (Fig. 8).
Once you successfully onboard your INSiGHT Scanning Technology, the Bridge will automatically pair to them each time you are within range and the instruments are powered on.