Performing a Segmental Thermal Scan

Once you have selected an Examiner, Scan Purpose, Range, Body Type and Test Protocol configured the wheels on your scanner, you are ready to being scanning. Click the Start Button and myINSiGHT™ will prompt you to begin the scan and prompt for the first location.

Place the neuroTHERMAL at the location and observe the thermal signal in the graph. Once the thermal signal stabilizes, take a reading by pressing the trigger on the neuroTHERMAL.

myINSiGHT™ will display the reading on the bar graph and prompt for the next location. Move the neuroTHERMAL to the next level, wait for the thermal signal to stabilize and take a reading.

Repeat this process until the scan is complete and you are prompted to save the scan. Select OK to save the scan.