Read out information prior to activation (in sleep mode)

The following page shows which information will be indicated on the screen upon successive READ button pressings while in sleep mode.

Note: After approx. 60 seconds without to press any button of the Fridge-tag the devices goes back into sleep mode; the display is blank again. Start from the beginning.

Press repeatedly READ to gather information.

After 1st pressing of READ		Display test: all segments activated
After 2nd pressing of READ		Indication of date and production test result: 16 February 2018/PASS (quality check passed)
After 3rd pressing of READ		Indicaton of the Network configuration Status: ( ) configured ( ) not configured (go to chapter Initial device configuration).
After 4th pressing of READ		Indication of the current temperature and which sensor is activated (internal/external). Display shows —.-°C if external sensor is not connected.
After 5th pressing of READ		Indication of configuration ID (e.g. 1234)
After 6th pressing of READ		Indication of upper alarm settings. Example shows duration and temperature limits: 10 hours, >+8°C, high
After 7th pressing of READ		Indication of lower alarm settings. Example shows duration and temperature limits: 1 hour, <–0.5°C, low
After 8th pressing of READ		Serial number of the device
After 9th pressing of READ		PCb number (manufacturer information)
After 10th pressing of READ		Battery power: 3 bars = full (>70%) 2 bars = half-full (30–70%) 1 bar = low (0–30%)** **Device should be recharged.
After 11th pressing of READ		Disable user clock adjust. For more information, please see chapter Activation process
After 12th pressing of READ		The display is blank again.