The activation of the SAP GUI processing is controlled via table /BTI/TE_CONTROL in each development system. In here an “Active” entry must exist for the relevant users to switch on the processing.
If an alternative RFC destination is to be used (e.g. for testing purposes), entries can be maintained in table /BTI/TE_CONTROL for the relevant users and these must be marked as “Active”. This forces Transport Expresso to use the specified RFC destination rather than the default TRANSPORT EXPRESS CONTROLLER one.
To switch this on for ALL users an Active entry is required in table /BTI/TE_CONTROL with a BLANK username. This will use the Active flag / RFC destination for all users in this case.