The quick start guide is to be used after installation and has only the key basics required to create a recording and a playback, please check the installation guide here if that process is not complete.
- Setup Test Plan
A test plan must first be setup prior to any recordings being performed or playbacks.
- Recording Preparation
This step ensures that the systems to be recorded are in the correct state to do so.
- Performing a Recording
This is the process for activating the recording on the source systems.
- Review Recordings
Once recording is complete, you should review the recordings that have been captured.
- Preparing Playback
Prior to starting the playback process, these steps must be performed to ensure the playback will be successful.
- Analyzing Coverage
Coverage analysis provides information on how much coverage is in the recording plus allows the objects to be prioritized.
- Execution of Playback
This is the actual playback process, automatically performed by the supporting “bots”.
- Review Playback Results
The end result of the process which high-lights discrepancies between what was recorded from the live system and what potential issues have been identified in the test system that is played back into.
Thanks for your feedback.