Purpose

Once Testimony has been installed into a system, the next step is to setup a “Test Plan”. This is an entity in Testimony which allows you configure which systems are to be recorded, which ones are to be played back into and then the triggering of the recording and playbacks into those systems. It is the fundamental entity with which you perform Testimony actions. Note that you can have as many test plans setup in the system as required and typically you would create a new test plan for separate test phases (although you can repeat multiple test cycles within the same test plan).

Audience / Users

Test Manager, Test team

Process Steps

The process of setting up a test plan is covered here.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment