Purpose

When you are ready to run a test phase leveraging the recording / learning capability in Testimony, you need to prepare the recording systems first. This may have already been done in the given system as a part of a previous test phase/cycle. In that case, you can simply perform the recording. However, if you need to set the system up for recording for the first time, that is done here.

Time Required

Approximately 1 hour per system

Audience / Users

Test Manager, Test team

Process Steps

The process of preparing a system for recording is made up of 3 steps:

(1) Generate Inbound RFC Capture – Prepares for inbound RFC calls to be captured.
(2) Activate enhancements – Prepares the system for capture of all interactions.
(3) Generate Outbound RFC – Prepares the system for outbound RFC calls to be captured.
(4) Activate Outbound RFC Capture – Prepares the external communication mechanism for outbound RFC capture.

Once the above steps are performed, the system is now ready to be recorded. Note that this must be done on each recording system in the test plan.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment