Follow these steps to change the sound produced by the effects pedals by setting new values for their controls:

Set control values
Figure 3.3.1: The “Drive” knob on a Tube effects pedal and the “←” button on the top bar.

  1. With playback active, press 1 on your keyboard and click the black pads on both pedals to activate their distortion effect. Note: When the pedal’s effect is active, their “Active” indicator lights up.
  2. Drag the “Drive” knob on either pedal up or down to set the amount of distortion applied to the signal connected to it.
  3. Experiment with other controls. Click the “←” button on the top bar to revert any unwanted changes.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment