Audiotool shows the “Template/track selection” dialog box when started. This dialog box offers four templates and lets you start your session with the corresponding arrangement loaded on the desktop. Follow these steps to open a predefined arrangement:

Load a template
Figure 3.1.2: The “Rookie Acid Vintage setup” button on the “Template/track selection” dialog box.

  1. Click the “Rookie Acid Vintage Setup” button on the “Template/track selection” dialog box. Audiotool shows a “Load” dialog box with information about the arrangement, a progress bar and a “Cancel” button.
  2. If Audiotool shows a “Quick Tour” dialog box after the load is complete, click the “No” button. Audiotool then shows the main interface with the arrangement on the desktop. Note: You can see the quick tour any time by selecting “Tutorials ► Show Quick Tour” on the top bar.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment