The merger is a simple device with a single section of controls. Note: The controls don’t have context menus; they can only be reset globally through the device context menu and automated through the “Create Track” item in the device context menu, the “Tracks” top bar menu or the “Add track” menu in the device and track list.

Merger controls
Figure 7.11.1: The merger's controls.

  1. Mix: This 2D slider sets the volume of each input signal in the mix. At the center, all input signals have the same volume. Drag the slider towards “A”, “B” or “C” to reduce the volume of the other input signals in the mix.
  2. Slope: This selector sets the shape of the decay in volume of the input signals as you drag the mix slider away from them. In the half range position, each input signal has full amplitude until halfway, then decays linearly. In the full range position, the amplitude of each input signal undergoes a slightly logarithmic decay over the whole range.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment