The master section provides controls to set the attenuation of the two auxiliary sends, as well as the output volume and panorama.

Centroid master section
Figure 7.16.2: The Centroid's master section.

  1. Send level 1 and 2: These knobs attenuate the volume of each auxiliary send output in decibels. Note: A signal connected to either auxiliary return will be heard only if you connect a device to the corresponding auxiliary send.
  2. Pan: This knob sets the panorama of the master output mix from hard left to hard right. Note: This knob sets panorama by crossing the left or the right channel to its opposite respectively. This might be relevant when panning a stereo signal.
  3. Level: This slider attenuates the volume of the master output mix in decibels.
  4. Peak meter: These indicators show a representation of the volume of the master output signal in the left and right audio channels respectively. Above each bar, a clipping indicator lights up whenever the signal volume in the corresponding channel causes clipping to occur.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment