The Audiotrack is a simple device with a single section of controls.

Audiotrack controls
Figure 7.14.1: The Audiotrack's controls.

  1. Balance: This knob sets the panorama of the output mix from hard left to hard right. Note: This knob sets panorama by attenuating the left or the right channel respectively. This might be relevant when playing back a stereo sample.
  2. Mute: This switch silences the output mix.
  3. Level: This slider attenuates the volume of the output in decibels. It can also boost it almost 2 dB above nominal level.
  4. Peak meter: These indicators show a representation of the volume of the output signal in the left and right audio channels respectively. Above each bar, a clipping indicator lights up whenever the signal volume in the corresponding channel causes clipping to occur.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment